Firmware

FRAVEX Support

Controller Firmware

Official GP2040-CE firmware for FRAVEX controllers. Pick your controller below and download its file — each model has its own firmware, so use only the one made for yours.

Choose your controller

Fravex 16-Key Leverless Arcade Controller

Fravex 16-Key Leverless Arcade Controller — Black (ABS)

Also for: Black (ABS) + PS5 Adapter Combo

Build: GP2040-CE 0.7.11PS4 / PS5
Fravex 16-Key Leverless Arcade Controller White Acrylic

Fravex 16-Key Leverless Arcade Controller — White (Acrylic)

Also for: White (Acrylic) + PS5 Bootloader Combo

Build: GP2040-CE 0.7.11PS4 / PS5
Fravex 16-Key Mini Leverless Arcade Controller

Fravex 16-Key Mini Leverless Arcade Controller

Also for: Mini + PS5 Bootloader Combo

Build: GP2040-CE 0.7.11PS4 / PS5
Fravex K-Box FightPad

Fravex K-Box FightPad

Also for: K-Box + PS5 Adapter Combo

Build: P5General v3.4 · GP2040-CE 0.7.12PS4 / PS5
Fravex MustFun FightPad with OLED

Fravex MustFun FightPad with OLED

Also for: MustFun + PS5 Adapter Combo

Build: P5General v3.4 · GP2040-CE 0.7.12PS4 / PS5

How to flash it

Normal update (all controllers)

  1. Unplug your FRAVEX controller from your console and PC.
  2. Put it into bootloader mode: hold the board’s boot button (the physical BOOTSEL button on the RP2040) and, while still holding, plug the USB cable into your PC. Release once connected.
  3. Your PC will show a new removable drive named RPI-RP2.
  4. Drag your controller’s firmware .uf2 file onto the RPI-RP2 drive.
  5. The drive disappears and the controller reboots on its own. The update is done.

Full reset (K-Box and MustFun only)

Use this if the controller acts strangely after an update, or the buttons are mixed up.

  1. Put the controller into bootloader mode as above, so the RPI-RP2 drive appears.
  2. Drag flash_nuke.uf2 onto the drive. It erases the controller completely, and the RPI-RP2 drive comes back by itself after a few seconds.
  3. Now drag your controller’s firmware file onto the drive. The controller reboots and is ready.

Important: flash_nuke on its own leaves the controller blank — it will not work until you flash the firmware file straight after.

Tip: To open the GP2040-CE web configurator, hold S2 while plugging the controller in, then visit http://192.168.7.1 in your browser.

Not sure which controller you have?

Send us a photo of your controller on WhatsApp or email support and we’ll tell you which file to use, and walk you through flashing it.